OUR EXCLUSIVE 6 STAGE EXTERIOR WALL PROCESS
We drill holes 1-1/2” diameter 15″ to 16” on center on the exterior Wall cavities. We make sure to go above and below the fire blocks, each cavity requires 2 holes minimum.
We then pump fire, insect & rodent deterrent cellulose insulation in the wall cavities using high pressure. This process compacts very densely, giving a high R-Value Rating.
We then use our exclusive under the surface patch to seal strengthen and lays a foundation for the texture stage patching.
The most critical stage of this process is the texture matching, Over 30 years of experience
goes into this process. The under surface patch from stage three fuses with our texture patch,
to form one solid surface. Unlike some of our competitors who only use one layer of patching that cracks and deteriorates in a short time. Our patch outlast the EXISTING STUCCO! We can guarantee on most homes a 100% texture match!
To give a turnkey service, we then do a “fog in” color match, on 70 to 80% of the wall surface.
The side benefit is a freshened up look on the whole exterior of your home, for nickels on the dollar!
Each wall is inspected for texture and color for a perfect match and consistency.
“Most homes look better when we leave than before we started!”
We 100% Guarantee that most homes will be good as new or better than when we started! If we cant give a 100% Guarantee on texture and color we will let you know up front!
This is a house that was built in 1958. Walls are 4″ thick and zero insulation. This is after Green Fiber Cellulose was put in the walls. The AC has been turned off for a day to run the test. Time of day was 4:30 pm and the outside temp was 96.1 degrees. As you can see there is a 40-degree difference between the outside wall and the inside wall. Less heat radiating through the walls means your heater and AC do not have to work as hard. 50% less heat load means 50% less on your utility bill.